Evan Designs U33F 3mm 19V Red Flashing LED (Pack of 5)
Evan Designs U33F 3mm 19V Red Flashing LED (Pack of 5)
Regular price
$15.89
Sale price
Unit price
per
$15.89
Regular price
Reg Price:
SPECIAL ORDER
These Super Bright Flashing LEDs come Fully Assembled with a super compact full wave Bridge Rectifier for always on forward and reverse operation, a capacitor, and a dropping resistor, all shrink tubed and ready to use with 6 of insulated wire.
Connect these LEDs to any track power source: AC DC or DCC. They will work great with 5-19 Volts of Power.
These Flashing LEDs don't need a circuit board, and look great as end of train devices, on Maintenance of Way vehicles, as Oscillating Headlights, at the top of Water Towers and Other Towers, on Emergency Vehicles, and more!
Brightness: 5,000 mcd
Flash Rate = 1.5 hz This is a nice flash rate for most uses.
Why Switch to LEDÆs?
There are many reasons to switch to LEDÆs instead of regular incandescent lighting!
LEDÆs do not get hot like an incandescent, so you will not melt the roof of your building or the housing of your train, water tower, or emergency vehicle! LEDÆs last and last!! Over 10 years (100,000 hours!) per light. So, you will not have to take apart your building or train to change out the lighting when it burns out! A standard incandescent bulb will last 750 hours or so. We guarantee our lights for two full years with free replacement. LEDÆs give a lot of light in a very small package. The LEDÆs we sell have a minimum of 5000 millicandels of light, approximately 1.45 Lumens. Some colors, like white, have 15,000 mcd. . Compare that to a GE 14 volt Midget bulb which gives approximately .3 lumens (mscp). LEDÆs are tough and durable. There is no filament to break, and the diode is encased in solid epoxy.
Can I wire these to my track power?
Yes, you can. Universal LEDs are specifically designed to run on any track power. These lights are plug and play pre-assembled. You need to do nothing more to these lights! Constant on lighting with DC, AC, or DCC track power. Refer to the diagram that came with your locomotive to check where to attach the leads for your particular loco. To light a passenger car, you will need to run the wire down to the track through the truck. In general, the red wire goes to the positive the black wire goes to the negative.
Condition: Factory New (C-9)
Operational Status: Functional
Original Box: Yes (P-9)
Manufacturer: Evan Designs
Model Number: U33F
Years Manufactured: 2007 - 2007
Category 1: Parts
Category 2: Control & Electrical
The Trainz SKU for this item is P11437967.
Trainz Product Id: 11437967
Connect these LEDs to any track power source: AC DC or DCC. They will work great with 5-19 Volts of Power.
These Flashing LEDs don't need a circuit board, and look great as end of train devices, on Maintenance of Way vehicles, as Oscillating Headlights, at the top of Water Towers and Other Towers, on Emergency Vehicles, and more!
Brightness: 5,000 mcd
Flash Rate = 1.5 hz This is a nice flash rate for most uses.
Why Switch to LEDÆs?
There are many reasons to switch to LEDÆs instead of regular incandescent lighting!
LEDÆs do not get hot like an incandescent, so you will not melt the roof of your building or the housing of your train, water tower, or emergency vehicle! LEDÆs last and last!! Over 10 years (100,000 hours!) per light. So, you will not have to take apart your building or train to change out the lighting when it burns out! A standard incandescent bulb will last 750 hours or so. We guarantee our lights for two full years with free replacement. LEDÆs give a lot of light in a very small package. The LEDÆs we sell have a minimum of 5000 millicandels of light, approximately 1.45 Lumens. Some colors, like white, have 15,000 mcd. . Compare that to a GE 14 volt Midget bulb which gives approximately .3 lumens (mscp). LEDÆs are tough and durable. There is no filament to break, and the diode is encased in solid epoxy.
Can I wire these to my track power?
Yes, you can. Universal LEDs are specifically designed to run on any track power. These lights are plug and play pre-assembled. You need to do nothing more to these lights! Constant on lighting with DC, AC, or DCC track power. Refer to the diagram that came with your locomotive to check where to attach the leads for your particular loco. To light a passenger car, you will need to run the wire down to the track through the truck. In general, the red wire goes to the positive the black wire goes to the negative.
Condition: Factory New (C-9)
Operational Status: Functional
Original Box: Yes (P-9)
Manufacturer: Evan Designs
Model Number: U33F
Years Manufactured: 2007 - 2007
Category 1: Parts
Category 2: Control & Electrical
The Trainz SKU for this item is P11437967.
Trainz Product Id: 11437967
WARNING:
This product can expose you to chemicals including but not limited to lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
Your order is professionally packed with high quality packing materials to offer the best possible protection during transit. If something should go wrong, we insure all packages against both loss and damage.
We’re committed to keeping our shipping prices low, and our delivery times fast. Our system will automatically choose the best carrier at the time of shipment to help us deliver the lowest prices possible.
The moment your order ships you will receive an automated email which provides confirmation of shipment. For most shipping services you will also receive a tracking number and a link to a page where you can track your shipment.
Sign In or choose a shipping location to see rates.
Your default address has been changed to:
We love happy customers and do our best to maintain a fair and hassle-free customer satisfaction policy. We will gladly repair or replace your item, issue a refund, or negotiate a partial credit.
Just contact us within 30 days of receipt of the item (or within 60 days if you are a Private Car member). Explain why the item does not meet your expectations and how you would like us to handle the issue. If your item has been damaged try to include a photograph of the actual damages. We'll do our absolute best to make you happy.
If you and Trainz decide that the best recourse is to return the item for refund or repair we will send you a pre-paid return shipping label. Make sure to include your contact and order information when you return your items. Once Trainz receives and inspects the items we will repair your item or issue a refund.
Trainz reserves the right to charge you:
- Return shipping if an item is returned to Trainz.
- 15% re-stocking fee if an item is not returned in its original condition.
- Any carrier charges resulting from a refused shipment.
For International orders only:
- Trainz does not refund shipping charges.
- Customers are responsible for paying return shipping.
Our return policy may differ on our other marketplaces such as eBay. If your item was not purchased on Trainz.com, please review the return policy where your item was purchased.
If you have any questions, don't hesitate to Submit a Support Ticket
